EPA07 MBE 4000 SERVICE MANUAL 2. Install the two new O-rings on the electronic unit pump shaft using the electronic unit pump O-ring installer (J–45373). See Figure 2-12. 1. Inner (larger) O-ring 2. Outer (smaller) O-ring Figure 2-12 O-ring 3. Install the EUP into the cylinder block. [a] Insert the EUP into the mounting hole in the cylinder block. [b] Use light hand pressure to push in the electronic unit pump until it seats, about 4 mm (0.16 inch). If it won't seat easily, rotate the crankshaft until the electronic unit pump seats. NOTE: Use the bolt mounting holes on the engine as a guide for positioning the injector pump. 4. Install the mounting bolts, and tighten to 65 N·m (48 lb·ft). 5.
Connect the engine wiring harness to the EUP. 6. Remove the engine barring tool (J–46392) and replace the inspection cover on the flywheel housing. Tighten the inspection cover mounting bolts to 25 N·m (18 lb·ft). PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 7. Connect the fuel line at the fuel gallery inlet. Tighten the fitting to 50 N·m (37 lb·ft). 8. Install the fuel lines and overflow valve on the fuel gallery outlet. Tighten all fasteners to 50 N·m (37 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-15