Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.1 ELECTRONIC UNIT PUMP [a] Install the inner banjo fitting, and two new seal rings, on the overflow valve, as marked on removal. [b] Install the threaded end of the overflow valve in the fuel gallery outlet. When the valve is firmly seated, tighten to 50 N·m (37 lb·ft). [c] Install the outer banjo fitting, again with two new seal rings, on the banjo bolt, as marked on removal. [d] Install the banjo bolt on the overflow valve and tighten to 50 N·m (37 lb·ft). 9. Install the fuel filter cap. Inspect the O-ring in the fuel filter and replace it if worn. Tighten the cap nut to 25 N·m (18 lb·ft). 10. Install the high-pressure fuel line and transfer tube. Refer to section 2.4.2.

ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 11. Start the engine and check for leaks. Tighten connections as needed. 12. Install the engine trim cover. All information subject to change without notice. 2-16 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION