EPA07 MBE 4000 SERVICE MANUAL 2.2 FUEL RETURN AND NOZZLE SPILL LINE The following sections support the repair of the fuel spill line. 2.2.1 Removal of Fuel Return and Nozzle Line Removal steps are as follows: FIRE To avoid injury from fire, keep all potential ignition sources away from diesel fuel, including open flames, sparks, and electrical resistance heating elements. Do not smoke when refueling. FIRE To avoid injury from fire caused by heated diesel-fuel vapors: Keep those people who are not directly involved in servicing away from the engine. Stop the engine immediately if a fuel leak is detected. Do not smoke or allow open flames when working on an operating engine.
Wear adequate protective clothing (face shield, insulated gloves and apron, etc.). To prevent a buildup of potentially volatile vapors, keep the engine area well ventilated during operation. 1. Remove two side and one rear engine trim cover. 2. Remove bolt (M6 x 20 mm) from rear trim cover bracket at air intake manifold and side bracket. 3. Remove air intake manifold. 4. Disconnect electrical connector at the electrostatic oil separator. 5. Remove the cylinder head covers. 6. Remove the fuel spill banjo bolt (M16) and washers at overflow valve on left side rear of the cylinder block. 7. Remove banjo bolt and washers (M8) from rear of fuel filter. Discard washers. 8.
Remove three bolts (M8 x 35) on clamps securing the return line on the left side of the cylinder block. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-17