2.2 FUEL RETURN AND NOZZLE SPILL LINE 9. Remove six banjo bolts and washers (M8) securing the nozzle spill line at each cylinder head and remove line. Discard the washers. 2.2.2 Installation of Fuel Return and Nozzle Line Installation steps are as follows: 1. Install six banjo bolts and new washers and secure the spill line at each cylinder head. Torque the banjo bolts to 15 N·m (11 lb·ft). 2. Install three bolts in clamps securing the fuel return line on the left side of the cylinder block. Torque the bolts to 25 N·m (18 lb·ft). 3. Secure the small nozzle spill line from the cylinder heads to the cylinder block with overflow valve and new washers.
Torque the overflow valve to 50 N·m (37 lb·ft). 4. Connect the large fuel return line to the overflow valve with the banjo bolt and new washers. Hold the overflow valve with a wrench and torque the banjo bolt (M16) to 50 N·m (37 lb·ft). 5. Install the banjo bolt and new washers in the large and small fuel spill line to the fuel pump. Torque the banjo bolt to 40-50 N·m (30-37 lb·ft). 6. Install the cylinder head covers. 7. Connect the electrical connector at the electrostatic oil separator. 8. Install the air intake manifold. 9. Install the two side and one rear engine trim cover. All information subject to change without notice. 2-18 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION