Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.6 FUEL INJECTOR 2. Lubricate a new fuel injector O-ring with a light coating of engine oil and install it on the fuel injector. 1. Fuel Injector 2. Heat Isolator Figure 2-26 Fuel Injector Heat Isolator 3. Using the injector heat isolator installer (J–47387–A), press the new heat isolator onto the fuel injector as follows: [a] Place the heat isolator installation tool (J–47387–A) in a vise. [b] Position the new heat isolator over the tip of the fuel injector. NOTICE: Ensure that the injector is properly seated in the installation tool or damage to the injector will result.

Do not apply excessive pressure to the injector or pound the heat isolator onto the injector, damage to the injector will result. [c] Install the tip of the injector into the installation tool and align the flats near the top of the injector with the slots in the installation tool. See Figure 2-26. [d] Turn the handle on the installation tool and press the heat isolator onto the injector tip. [e] Remove the injector from the installation tool and inspect the heat isolator for proper fit. NOTE: Take care that the fuel injector is installed correctly and is aligned properly with respect to the transfer-tube. All information subject to change without notice.

2-38 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION