Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 7. Remove the bolt from the fuel pump driven gear and use a puller to remove the gear. See Figure 2-39. 1. Driven Gear Mounting Bolt 5. Fuel Pump Gasket 2. Fuel Pump Driven Gear 6. Fuel Pump Assembly 3. Retaining Ring (2) 7. Fuel Pump Mounting Bolts 4. Fuel Pump Drive Assembly Figure 2-39 Fuel Pump Drive Assembly 8. Remove the snap ring from the front of the cylinder block and inside the drive assembly bore. 9. Using fuel pump bearing driver (J-47073), drive the bearing out from the front of engine. If bearing is bad replace the bearing, refer to section2.14.2 and see Figure 2-40.

Figure 2-40 Fuel Pump Bearing Driver J-47073 All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-61