Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.14 FUEL PUMP DRIVE 2.14.2 Installation of Fuel Pump Drive Installation steps are as follows: 1. Install the snap ring in the backside of the cylinder block fuel pump drive bore. See Figure 2-39. 2. From the front of the engine and using fuel pump bearing driver (J–47073) drive the fuel pump drive assembly into the housing until it contacts the snap ring. See Figure 2-40. 1. Torque Wrench 3. Fuel Pump 2. Fuel Pump Drive Gear Splines 4. Fuel Pump Gasket Figure 2-41 Fuel Pump Drive Gear 3. Install the snap ring in the front side of the cylinder block fuel pump drive bore to secure the fuel pump drive. See Figure 2-39. 4. Install fuel pump driven gear and bolt.

Apply Loctite® 271 sealant to the bolt threads and install gear and bolt. Install the fuel pump gear locking device (J–46187) to the fuel pump drive splines and secure the shaft from turning while torquing bolt. See Figure 2-41 and Figure 2-38. 5. Torque the driven gear bolt to 35 N·m (26 lb·ft). 6. Install the camshaft cover. Torque the bolts to 50 N·m (37 lb·ft). 7. Install the fuel pump and a new fuel pump gasket. Refer to section 2.13.2. 8. Install the alternator/air conditioning bracket. 9. Install the crankshaft vibration damper on the crankshaft. 10. Install the fan on the water pump pulley and secure with six bolts (M8 x 12mm). Torque the bolts to 25 N·m (18 lb·ft).

All information subject to change without notice. 2-62 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION