Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.15 FUEL DOSER VALVE (FDV) 3. Disconnect the fuel doser supply line from the fuel doser injector valve. Hold the fuel doser injector valve with a wrench when loosening the fuel doser supply line fitting. NOTE: Use care not to bend the fuel line during injection valve removal. 4. Remove the fuel doser injector valve from the housing. 2.15.2 Installation of Fuel Doser Injector Valve Installation steps are as follows: 1. Clean the doser housing injector valve seat with a suitable brush, taking care not to damage the seat. NOTE: Do not use a hard bristle brush as it could damage the seat. 2. Install the fuel doser injector valve into the fuel doser housing and torque to 20 N·m (14 lb·ft). 3.

Connect the fuel doser supply line to the fuel doser injector valve. Hold the fuel doser injector valve with a wrench while torquing. Torque to 18 N·m (13 lb·ft). 4. Install the protective cover (if equipped). ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 5. Start the engine. NOTE: It may take more than one purge attempt to completely purge all of the air from the fuel line. 6. Using DDDL 7.X, command the Purge function. 7. Check for exhaust leaks. 8. Shut off the engine. 2.15.3 Removal of the Fuel Doser Housing Remove as follows: 1. Drain the cooling system.

All information subject to change without notice. 2-64 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION