EPA07 MBE 4000 SERVICE MANUAL 2. Disconnect the upper dosing fuel line from the FDV. 3. Remove the two bolts at clamps securing the upper dosing fuel line to brackets. See Figure 2-43. 4. Remove the two bolts at clamps securing the upper dosing fuel line to the right side rear of the cylinder block. See Figure 2-43. 5. Remove the bolt and nut at the clamp securing the upper dosing fuel line to the rear engine lifting bracket. See Figure 2-43. 6. Disconnect fitting at the connector union and remove the upper dosing fuel line. 7. Remove the two bolts at the clamps securing the lower dosing fuel line to the rear left side of the flywheel housing. See Figure 2-43. 8.
Disconnect the fitting connection at the doser block assembly, located on the left side rear of the engine, and remove the lower fuel dosing line. See Figure 2-43. 2.15.6 Installation of Dosing Fuel Line Installation steps are as follows: 1. Connect and hand-tighten the dosing fuel line fitting connection to the doser block assembly. 2. Connect and hand-tighten the upper dosing fuel line to the connector union fitting which is installed on the fuel line going to the doser block assembly. 3. Connect and hand-tighten the upper fuel dosing line to the Fuel Dosing Valve (FDV). 4. Install and hand-tighten all securing clamps to the engine block and the flywheel housing. 5.
Move the dosing fuel line assembly forward and backward to ensure it is tension-free. 6. Torque the nut connections at the doser block assembly to 15 N·m (11 lb·ft). 7. Torque the FDV connector union fitting to 15 N·m (11 lb·ft). 8. Torque all clamps to 25 N·m (18 lb·ft). 9. Secure the upper cover of the FDV with three bolts. Torque the bolts to 10 N·m (7 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-67