2.16 DOSER BLOCK ASSEMBLY 2.16 DOSER BLOCK ASSEMBLY The Doser Block Assembly is part of the Aftertreatment System (ATS) and is used to control the fuel being injected into the exhaust for the cleaning of the Diesel Particulate Filter (DPF). 2.16.1 Removal of Doser Block Assembly Removal steps as are follows: 1. Disconnect the electrical harness connectors to the fuel cutoff valve, fuel compensation pressure sensor, electronic dosing valve and fuel line pressure sensor, on the doser block assembly (1). 2. Disconnect the fitting (2) to the dosing fuel line (3) on the doser block assembly (1). 3.
Remove the banjo bolt, fitting and washers (5) connecting the fuel supply line (4) to doser block assembly (1). Discard the washers. 4. Remove the three bolts securing the doser block assembly to the mounting bracket and remove the assembly. 2.16.2 Removal and Cleaning of the Fuel Compensation Pressure Sensor Remove the Fuel Compensation Pressure sensor as follows: 1. Shut off the engine, apply the parking brake, chock the wheels, and perform any other applicable safety steps. 2. Clean all dirt and debris from the surrounding area of the Fuel Compensation Pressure sensor prior to removal. 3. Remove the Fuel Compensation Pressure sensor electrical connector.
All information subject to change without notice. 2-68 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION