Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. Remove the two torx bolts from the sensor housing. 5. Remove the Fuel Compensation Pressure sensor (1) from the Doser block assembly. 6. Clean the Doser block where the Fuel Compensation Pressure sensor attaches. 2.16.3 Installation of the Fuel Compensation Pressure Sensor Install the new sensor as follows: 1. Lubricate the new O-ring with clean diesel fuel and install it on the fuel compensation sensor. 2. Install the Fuel Compensation Pressure sensor using two bolts; torque the bolts to 11 N·m (8 lb·ft). 3. Start the engine and check for diesel fuel leaks. 4. Perform a Fuel Doser Purge Service Routine using the DDDL 7.X. NOTE:

Perform the Fuel Doser Purge Service Routine only once. [a] Using DDDL 7.X, initiate a parked regeneration. [b] Verify that a parked regeneration has completed. [c] Verify repair. 2.16.4 Installation of Doser Block Assembly Installation steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-69