Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

3.7 OIL COOLER/FILTER HOUSING 3.7 OIL COOLER/FILTER HOUSING Perform the following procedures for removal and installation of the oil cooler/filter housing. 3.7.1 Removal of Oil Cooler/Filter Housing Removal steps are as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. When the engine is cool, drain the coolant from the radiator. 2. Remove the turbocharger from the engine. 3.

Disconnect the coolant pump shunt line from the coolant pump inlet pipe and move it out of the way. 4. Remove the oil filter cap. Inspect the O-ring and filter for damage and replace them if necessary. Drain the oil remaining in the filter into a clean container. 5. Disconnect the wiring harness from the oil pressure/temperature sensor. 6. Remove the banjo bolt and washers securing the oil lines to the oil cooler/filter housing. Discard washers. All information subject to change without notice. 3-24 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION