Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 7. Remove the oil cooler/filter housing from the cylinder block. See Figure 3-21. Catch any oil that drains out in a clean container. Discard the gasket and set aside the housing. Mark the bolts with a paint marker for location and later installation. 1. Cylinder Block 6. Oil Filter Cap 2. Gasket 7. Engine Identification Plate 3. Oil Filter Element 8. Oil Pressure/Temperature Sensor 4. Oil Cooler/Filter Housing 9. Oil Cooler Bolts 5. Oil Filter Housing Figure 3-21 Oil Cooler/Filter Housing NOTE: The oil filter housing and the oil cooler housing are part of the same casting. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-25