Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 3. Install the oil cooler/filter housing on the cylinder block. Install the housing bolts and tighten them in the order shown in see Figure 3-24. Tighten each bolt to 60 N·m (44 lb·ft). Figure 3-24 Oil Cooler Housing Bolts [a] Clean the mating surfaces of the oil cooler/filter housing and the cylinder block. Remove any bits of adhering gasket material. [b] Replace the oil cooler/filter housing gasket. 4. Install a new filter element and O-ring in the oil filter housing. See Figure 3-25. 1. Oil Filter Cap 3. Oil Filter Element 2. O-ring Figure 3-25 Oil Filter Element 5. Install the oil filter cap. Tighten the cap nut to 25 N·m (18 lb·ft).

All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-29