Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

3.7 OIL COOLER/FILTER HOUSING 6. Secure the oil lines to the oil cooler/filter housing with a banjo bolt and new washers. Tighten the banjo bolt to xx N·m (xx lb·ft). 7. Install the oil pressure/temperature sensor on the oil cooler/filter housing. Refer to Section 3.8.2. 8. Connect the wiring harness to the oil pressure/temperature sensor. 9. Install the turbocharger on the engine. Refer to section 6.7.3. 10. Connect the coolant pump shunt line to the coolant pump inlet pipe. 11. Fill the cooling system. Refer to section 4.1.1. ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 12. Start the engine.

Check the gauge for the correct oil pressure; check the oil lubrication system and the coolant pump inlet pipe for leaks. The correct oil pressures are listed in Table 3-3. Table 3-3 Engine Oil Pressures All information subject to change without notice. 3-30 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Engine Speed Minimum Pressure kPa (psi) At idling rpm 50 (7) At maximum rpm 250 (36)