EPA07 MBE 4000 SERVICE MANUAL 3.8 ENGINE OIL PRESSURE/TEMPERATURE SENSOR The Engine Oil Pressure/Temperature Sensor is located on the oil cooler/filter housing. Perform the following procedures for removal and installation of the oil pressure/temperature sensor. 3.8.1 Removal of Engine Oil Pressure/Temperature Sensor Removal steps are as follows: 1. Loosen the oil filter cap. Lift up the cap and filter to allow the oil to drain. Inspect the O-ring for damage and replace if necessary. 2. Disconnect the wiring connector from the oil pressure/temperature sensor. See Figure 3-26. 1. Oil Filter 2. Engine Oil Pressure/Temperature Sensor Figure 3-26 Engine Oil Pressure/Temperature Sensor Location 3.
Remove the two bolts securing the Engine Oil Pressure/Temperature Sensor to the oil filter housing. 3.8.2 Installation of Engine Oil Pressure/Temperature Sensor Install the Engine Oil Pressure/Temperature Sensor as follows: 1. Install the Engine Oil Pressure/Temperature Sensor in the oil filter housing and secure with two screws. Torque the screws to 8 N·m (6 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-31