Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4.4 THERMOSTAT Perform the following procedures for removal and installation of the thermostat. 4.4.1 Removal of Thermostat Removal steps are as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain the coolant from the engine. Refer to section 4.1.1. 2. Remove the upper coolant tube from the thermostat housing. See Figure 4-10. 1. Upper Thermostat Housing 4. Thermostat 2. Mounting Bolt 5. Coolant Pump Housing 3.

Seal-Ring Figure 4-10 Thermostat All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-19