4.4 THERMOSTAT 3. Remove the mounting screws attaching the thermostat housing to the coolant pump housing. Remove the thermostat housing. NOTE: Catch any coolant that runs out of the upper coolant tube or coolant pump housing. 4. Remove the thermostats and seal rings from the coolant pump housing. Discard the seal rings. 5. Check both thermostats for proper operation. For detailed procedures, refer to section 4.4.1.1. Replace any thermostat that fails one or more tests. 4.4.1.1 Checking of Thermostat Checking steps are as follows: 1. Remove the thermostat from the coolant pump housing. Refer to section 4.4.1. 2. Hang the thermostat by a wire inside a container filled with water.
See Figure 4-11. 1. Thermostat 2. Container Figure 4-11 Heat the Thermostat NOTE: To allow the thermostat to heat evenly, make sure it is not touching the sides of the container. NOTICE: To prevent damage to the thermostat or heating container, do not ever use a welding torch or soldering gun as a source of heat. 3. Heat the water with a suitable heating element. Stir the water occasionally to help equalize the temperature. All information subject to change without notice. 4-20 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION