Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

6.3 GAS MIXER HOUSING 6.3 GAS MIXER HOUSING Perform the following procedures for removal and installation of the gas mixer housing. 6.3.1 Removal of Gas Mixer Housing Removal steps are as follows: 1. Disconnect the hose connection from the charge air cooler to the intake throttle adaptor. 2. If equipped with a grid heater disconnect the electrical connections and harness connector. 3. Disconnect the electrical connector from the intake air temperature/pressure sensor on the mixer housing. 4. Disconnect the electrical connector from the air intake throttle valve. 5. Remove fuel primer pump. 6.

For engines equipped with the Extreme Cold Climate (EC2) Package, remove the coolant feed line from the intake throttle valve. All information subject to change without notice. 6-10 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION