EPA07 MBE 4000 SERVICE MANUAL 6.4 AIR INTAKE MANIFOLD Perform the following procedures for removal and installation of the air intake manifold. 6.4.1 Removal of Air Intake Manifold Removal steps are as follows: PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 1. Apply the parking brakes, shut down the engine, and chock the rear tires. Tilt the hood. 2. Remove the hose clamps at the air compressor, air intake manifold and EGR cooler securing the air compressor air inlet tube to brackets. 3. Remove the gas mixer housing. Refer to section 6.3.1. 4.
Remove front, two side, and one rear engine trim cover and mounting frames. Refer to section 1.1.1. 5. Disconnect the oil separator from the air intake manifold by loosening the upper hose clamp. 6. Disconnect the hose at the crankcase breather pipe hose at the rear of the air intake manifold by squeezing the clamp and pulling outward. 7. Remove the banjo bolt and two washers securing the electrostatic oil separator drain hose to the bottom of the air intake manifold. Discard the washers. 8. Remove twelve special bolts and washers and remove the air intake manifold and gaskets. Discard washers and gaskets. 9. Remove the intake air temperature/pressure sensor from the gas mixer housing.
Refer to section 6.6.1. 6.4.2 Installation of Air Intake Manifold Installation steps are as follows: 1. Install new gaskets on the air intake manifold and secure the manifold to the cylinder head with twelve special bolts (M8 x 100 mm) and new washers. Torque the bolts to 33 N·m (24 lb·ft). 2. Connect the electrostatic oil separator return line to the bottom of the air intake manifold with banjo bolt and new washers. Torque the banjo bolt to 35 N·m (26 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-13