EPA07 MBE 4000 SERVICE MANUAL 3. Install a sleeve into each exhaust manifold end piece. NOTE: The sleeve should be aligned linear with the exhaust manifold end pieces. If necessary, tap the sleeve with a rubber mallet to properly position the sleeve. 4. Position the exhaust manifold end pieces and center piece machined face down on a flat work surface. 5. Install a bellow connector to each end piece. 6. Install two V-clamps to each bellow and hand-tighten. NOTE: Do not torque the V-clamps and ensure that the clamps are positioned head-end up and 90° to the workbench. 7. Install the exhaust manifold end pieces to the exhaust manifold center piece. Torque the V-clamp bolts to 8 N·m (6 lb·ft).
8. Install the alignment plates (J-48670–1 and J-48670–2) to exhaust manifold and secure with bolts. See Figure 7-7. Torque bolts to 20 N·m (15 lb·ft). 1. Exhaust Manifold Assembly 2. Bolts Figure 7-7 Exhaust Manifold Alignment Plates All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 7-9