7.1 EXHAUST MANIFOLD ASSEMBLY NOTICE: To avoid exhaust gas leaks during engine operation, ensure that the exhaust manifold end pieces are parallel with the exhaust manifold center piece. 9. Using a suitable straight edge, place the straight edge along the length of the top machined surface of the exhaust manifold. If not aligned properly, adjust the sections as necessary. Figure 7-8 Exhaust Manifold Alignment Check 10. Install the upper heat shields to the exhaust manifold assembly and secure with six M8 x 12 mm bolts. Torque bolts to 25 N·m (18 lb·ft). 11. Install the exhaust manifold assembly to the cylinder heads and secure with bolts.
Using a crisscross sequence, torque the 12 mounting bolts to 50 N·m (37 lb·ft) plus an additional 90°. 12. Remove the alignment plates J-48670. 13. Install the lower heat shields with bolts. Torque bolts to 25 N·m (lb·ft). All information subject to change without notice. 7-10 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION