EPA07 MBE 4000 SERVICE MANUAL [d] Remove three washers and one spring from the assembly. See Figure 7-10. Figure 7-10 Brake Gate Lever Assembly [e] Remove the two bolts securing the bracket and actuator cylinder to the brake gate housing. See Figure 7-9. [f] Remove the two bolts and nuts securing the bracket at the top and remove the assembly. Remove the one remaining spring and washer from the shaft. See Figure 7-9. 7.2.2 Installation of Brake Gate Actuator Cylinder and Bracket Installation steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 7-13