Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. Install two washers, a spring, a washer, and the lever onto the brake gate shaft. Secure the lever with a bolt and nut. Torque the bolt to 11N·m (8 lb·ft) and an additional 90 degrees. See Figure 7-12 for an assembled lever assembly. Figure 7-12 Brake Gate Lever Assembly 5. Install the actuator cylinder ball socket to the lever and secure using a retaining clip. 6. Connect the actuator air line to the actuator cylinder. See Figure 7-11. 7. Install the air cleaner. 8. Connect the battery cables, lower the hood, and remove the chocks from the rear wheels. 7.2.3 Removal of Brake Gate Actuator Cylinder Removal steps are as follows: 1.

Disconnect the air supply line to the brake gate actuator. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 7-15