7.2 BRAKE GATE 2. Remove the retaining clip securing the ball socket to the ball fitting. Pry the ball socket from the ball fitting. See Figure 7-13. 1. Lever 5. Brake Gate Actuator Cylinder 9. Ball Socket 2. Nut 6. Washer 10. Retaining clip 3. Actuator Mounting Bracket 7. Bolt 11. Ball Fitting 4. Spacer 8. Nut Figure 7-13 Brake Gate Actuator Cylinder and Related Components 3. Remove the bolt. washer, spacer, and nut securing the brake gate actuator cylinder to the mounting bracket and remove the actuator. See Figure 7-13. 7.2.4 Installation of Brake Gate Actuator Installation steps are as follows: 1. If removed, connect the actuator lever to the brake gate and secure with bolt and nut.
Torque the bolt and nut to 11 N·m (8 lb·ft) and an additional 90 degrees. 2. Attach the brake gate actuator to the mounting bracket with a bolt, washer, spacer and nut. Torque the actuator bolt, and nut on the mounting bracket to 25 N·m (18 lb·ft). See Figure 7-13. 3. Connect the air supply line to the actuator. Tighten the fitting securely. All information subject to change without notice. 7-16 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION