EPA07 MBE 4000 SERVICE MANUAL 7.2.5.1 Repair of Brake Gate Repair steps are as follows: 1. Remove the brake gate shaft and two bushings from the brake gate plate. See Figure 7-16. 1. Roll Pins 3. Bearings 2. Shaft 4. Housing Plate Figure 7-16 Brake Gate Assembly 2. Position the brake gate assembly on top of an open vise with the flat flange (turbocharger side) facing upwards. Using a small diameter (approximately 2.5 mm) pin drift, drive the alignment roll pins from their bores and discard the pins. 3. Clean the brake gate housing and inspect for cracks or gouges on the mounting faces. If damaged, replace the brake gate assembly. 4. Clean the brake shaft and bushing.
Visually check components for wear, free rotation, and axial play. [a] If components are damaged, replace components as necessary. [b] If components are not damaged, reuse components and go to step 5. 5. Position the brake gate housing on top of an open vise with the flat flange facing upwards. Using a small diameter (approximately 2.5 mm) pin drift, drive new alignment roll pins into the plate until they are 1.0 mm (0.039 in.) below the face of the plate. 6. Install the bushings on each end of the brake gate shaft. Position shaft and bushings so the grooves in each bushing are aligned with the two small roll pins. See Figure 7-16. 7. Install the brake gate and shaft. Refer to section 7.2.6.
7.2.6 Installation of Brake Gate Install the brake gate as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 7-19