7.2 BRAKE GATE 1. Clean both sides of the brake gate with a suitable solvent. Also clean the sealing surfaces of the exhaust manifold and turbocharger mounting flanges, using a suitable solvent and Scotch pads. 2. If removed, install two studs into the rear bores of the exhaust manifold center section. Torque the two studs to 50 N·m (37 lb·ft). 3. Install two dowel pins into the exhaust manifold center section. See Figure 7-17. NOTE: Some brake gates were built with a two roll pin design. 1. Roll Pins 3. Bearings 2. Shaft 4. Housing Plate Figure 7-17 Brake Gate Assembly 4. Coat the mounting flange area of the center exhaust manifold section with heavy duty anti-seize compound.
Take care not to get compound in the area of the bushing bores and roll pin bores. 5. Align the brake gate assembly with the two dowel pins on the exhaust manifold. NOTICE: To avoid roll pin damage, ensure the brake gate assembly is properly seated against the center section of the exhaust manifold. 6. Install the brake gate assembly to the exhaust manifold and secure using two nuts onto the rear studs and two bolts and nuts through the front holes. Hand tighten the nuts in a All information subject to change without notice. 7-20 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION