Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

7.2 BRAKE GATE 7.2.7 Removal of Brake Gate Solenoid Remove the brake gate solenoid as follows: 1. Banjo Bolt 6. Brake Gate Solenoid 11. Washers 2. Washers 7. Bolts 12. Banjo Bolt 3. Actuator Air Line 8. Washers 13. Air Line 4. EPV 9. Banjo Fitting 14. Washer 5. Bolt 10. Adaptor Fitting 15. Adaptor Fitting Figure 7-22 Brake Gate Solenoid 1. Disconnect the harness connector at the brake gate solenoid. 2. Remove the banjo bolt and washer attaching the actuator air line to the side of the solenoid. Discard the washers. See Figure 7-22. 3. Remove the adaptor fitting and washer from the side of the solenoid. Discard the washer. 4.

Remove the banjo bolt and washers from the air line on the bottom of the exhaust brake gate solenoid. Discard the washers. See Figure 7-22. 5. Remove the adaptor fitting, banjo fitting and washers from the bottom of the solenoid. Discard the washers. 6. Remove the two bolts securing the brake gate solenoid to the mounting bracket and remove the solenoid. See Figure 7-22. All information subject to change without notice. 7-24 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION