Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

8.1 EGR GAS INLET PIPE 4. Install EGR gas inlet pipe to the exhaust manifold and secure using clamp halves, flanged nuts, and bolts. See Figure 8-2. 5. Secure clamp (11) using bolt and flanged nut. See Figure 8-2. 6. Secure clamp (3) using flanged nuts and bolts. See Figure 8-2. 7. Torque mounting bracket flange nuts to 50 N·m (37 lb·ft). 8. Torque clamp halves flange nuts to 25 N·m (18 lb·ft). NOTICE: To ensure to not damage the bellows when applying torque to the inlet pipe nut, secure the inner clamp half of the inner clamp and the rear exhaust manifold from rotating.

Placing a 13 mm (0.5 in.) spacer block between the gas inlet pipe and the exhaust manifold will ensure the part is located correctly during installation. 9. Torque EGR gas inlet pipe nut to 150N·m (110 lb·ft) / +10 N·m (7 lb·ft). 10. Torque bolts (14) to 25 N·m (18 lb·ft). 11. Torque bolts (13) to 25 N·m (18 lb·ft). 12. Torque bolts (16) to 50 N·m (37 lb·ft). 13. Torque bolts (1) to 25 N·m (18 lb·ft). All information subject to change without notice. 8-6 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION