EPA07 MBE 4000 SERVICE MANUAL 8.7 EGR CONTROL VALVE The EGR control valve controls the quantity of exhaust gas returning back to the intake manifold. 8.7.1 Removal of EGR Control Valve Removal steps are as follows: 1. Remove the EGR gas outlet pipe. Refer to section 8.2.1. 2. Remove the EGR control valve cover by removing the mounting bolts at the front lifter bracket and the rear of the EGR valve. See Figure 8-13. 1. EGR Control Valve Cover Mounting Bolts Figure 8-13 EGR Control Valve Cover 3. Remove connector pipe from the EGR control valve. 4. Disconnect wiring harness connector from the EGR valve. 5. Remove the four bolts attaching the EGR control valve to the thermostat housing. 6.
Pull the EGR control valve out of the EGR cooler. 7. Remove connector pipe from the EGR cooler or EGR control valve. 8.7.2 Installation of Installation of EGR Control Valve Installation steps are as follows: 1. Coat the rubber of the connector pipe with International Product Corporation Rubber Lubricant Emulsion (P-80) and insert the connector pipe into the EGR cooler. 2. Coat the connector pipe with International Product Corporation Rubber Lubricant Emulsion (P-80) and insert the EGR control valve onto the connector pipe. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 8-23