Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1. Disconnect the batteries. 2. Release the tension on the fan drive poly-vee belt. See Figure 9-1. [a] Place a socket wrench on the tensioner pulley bolt. [b] Pull the socket wrench (rotate the tensioner pulley clockwise) to remove the tension from the belt. [c] Hold the tensioner pulley in this position for the next step. 3. Remove the drive poly-vee belt from the fan and vibration damper pulley. Be careful not to kink, stretch, or otherwise damage the belt. See Figure 9-4. 1. Crankshaft Pulley 4. Fan Poly-Vee Belt 2. Idler Pulley #1 5. Fan Pulley 3. Fan Belt Tensioner 6. Idler Pulley #2 Figure 9-4 Fan Poly-Vee Belt 4. Release the fan belt tensioner. 5.

Inspect the fan poly-vee belt for nicks, wear, or other damage. Replace the belt if necessary. 6. Inspect the vibration damper pulley, the fan pulley, and the belt tensioner. Replace any that are damaged or worn: 9.1.4 Installation of Fan Belt Installation steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 9-7