EPA07 MBE 4000 SERVICE MANUAL 1.4.1.1 Inspection of Cylinder Liner Bore Inspection steps are as follows: 1. Check the wall of the cylinder liner for signs of excessive wear or deformation. 2. Check the honing pattern on the cylinder liner for damage caused by penetration of dirt into the cylinder. If the honing pattern is faded or no longer visible, discard the cylinder liner. See Figure 1-17 for an intact honing pattern and see Figure 1-18 for a faded honing pattern. NOTE: Minor fading of the honing pattern at the top ring inversion area is not sufficient cause to reject the cylinder liner. Figure 1-17 Intact Honing Pattern Figure 1-18 Faded Honing Pattern 3.
Do an external visual check of the cylinder liner for signs of cavitation and corrosion. Discard the cylinder liner if any damage is noted. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-25