EPA07 MBE 4000 SERVICE MANUAL NOTICE: Keep the engine running at idling speed until an oil pressure reading is obtained. If no oil pressure is shown after approximately 10 seconds, stop the engine and determine the cause. Failure to do so could result in engine damage. 11. Check the filter and oil drain plug for signs of leakage. 12. Stop the engine. Check the oil level again after approximately five minutes. If necessary, add oil up to the maximum fill level on the oil dipstick. 14.1.6 Coolant Concentration and Inhibitor Level Checking Check the coolant concentration as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 14-15