Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 8. Pressurize the system with 2 bar (29 psi). Use the pressure regulator to set the pressure. 9. Check for leaks around the all cover plates and plugs using a soap solution. Eliminate leaks. 10. Close the shut off valve. 11. Watch the pressure for 30 seconds. If the pressure holds at the 2 bar (29 psi), the cylinder block coolant system is properly sealed. In case of a pressure drop, the engine block should not be reused.

1.4.2 Cylinder Block Preparation This procedure is used with the PT-2250-B counterbore tool and J-41065. 1. Collar Seat Insert (shim) 4. Liner Seat D-Ring 2. Cylinder Block A. Specified in Measuring Cylinder Liner Protrusion Table 3. Cylinder Liner Figure 1-30 Cylinder Liner Collar Seat 1. Remove the cylinder heads, pistons, liners, and other hardware. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-35