Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.4 CYLINDER BLOCK 2. Protect the crankshaft, oil, and coolant passages from machining debris by covering with a shop towel or a suitable clean cover. Clean the top surface of the block to remove any debris from the machining area. 3. Remove the cylinder block dowel pins using (Snap-On CG503 or equivalent). 4. Remove the coolant pump refer to section 4.2.1 and the rear lifting bracket. narf 5. Protect internal engine parts from cutting debris using an oiled sponge filler in the cylinder block. 6. The cutting edge of the cutting bit should be retracted to protect the cutting tool. Cap screws of the cutter should be loose at this time. 1. Cylinder Block 2.

Cutter Plate Figure 1-31 Cross Section 7. Center the tool on the top of the block using the Counter Bore Cutter tool(J-41065). 8. Raise the depth stop adjustment collars and lower the tapered cutter plate into the bore. Rotate the tool and allow it to center itself in the bore. See Figure 1-31. All information subject to change without notice. 1-36 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION