Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 9. Install two opposing cylinder head bolts, with the washers and spacers through the base plate of the tool. See Figure 1-32. Tighten securely to 41 N·m (30 lbs. ft.). 1. Cylinder Head Bolt 3. Special Tool (J-41065) 2. Special Tool (PT-2250–B) 4. Cylinder Block Figure 1-32 Cutting Tool NOTICE: After machining the cylinder block, inspect for the presence of a chamfer on the edge of the balcony. Use a hand stone to break the sharp edge if needed. 10. Raise the tapered cutter head from the block and install the depth set spacer provided.

While there is no load, extend the cutting tool outward (using a clockwise rotation of the cutting screw) until it just touches a 0.15mm feeler gauge or shim placed next to the vertical wall of the counterbore. Tighten the Allen head hold-down screws. See Figure 1-32. NOTICE: Do not turn past this position or the cutter plate will fit and prevent an accurate reading. 11. Lower the cutting plate and cutter tool into the counterbore until it just touches the lower surface of the counterbore. Rotate the lock collars downward until they touch the bronze bushing of the tool. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-37