1.4 CYLINDER BLOCK 12. Set the depth of cut by adjusting the top collar upwards to allow the liner shim to be inserted between the two collars. Tighten the thumb screw of the top collar. Remove the shim. 13. Lubricate the tool bushing. Back off the lower collar by two graduations 0.0254 mm (0.001 in. each). Rotate the T-handle clockwise with a moderate, constant pressure. Stop at random positions to prevent creating a ridge in the counterbore. Continue backing off the adjustment in 0.0508 mm (0.002 in.) increments for the balance of the cutting operation until the collars come together. 14. Raise the handle and insert the spacer block under the lower collar.
Remove the hold-down bolts and spacers to remove the tool from the block. 15. Retract the cutter bit into the cutter plate to protect during storage. 1.4.3 Installation of Cylinder Liner Installation steps are as follows: 1. Perform the Measurement of Cylinder Liner Protrusion procedure.refer to section 1.4.1.3 2. Install new O-rings, clean and dry, in the cylinder block. 3. Install Liner Seat D-Ring to Cylinder Liner. Be sure the D-ring is installed with the flat surface of the of the ring against the liner. Be careful not to over-stretch the ring as it is installed over the liner flange. See Figure 1-33. 1. Collar Seat Insert (shim) 4. Liner Seat D-Ring 2. Cylinder Block A.
Specified in Measuring Cylinder Liner Protrusion Table 3. Cylinder Liner Figure 1-33 Cylinder Liner Seat NOTE: The cylinder liner collar and collar seat must remain completely free of oil. All information subject to change without notice. 1-38 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION