Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 6. Inspect the piston for damage and signs of wear. Remove the seal ring from the piston and discard. If necessary, replace the piston. 7. Insert the constant throttle valve (CTV) spring remover (J–46401) down onto the spring retainer. Remove the valve keepers with a magnet. See Figure 1-42. 1. Valve Keepers 3. Spring 2. Spring Retainer Figure 1-42 Compressing the Spring 8. Relieve the pressure on the spring. Remove the spring retainer, spring and spring guide. For ease of installation, mark the spring retainer and spring guide with a paint pen. 9. Turn over the cylinder head. From the bottom of the cylinder head, draw out the valve and spacer.

For ease of installation, mark the valve with a paint pen. 10. Using a small hook, remove and discard the valve stem seal. NOTE: Always replace the valve stem seal whenever the constant-throttle valve is removed. 11. Repeat this procedure for each constant-throttle valve. 1.6.2 Installation of Constant Throttle Valve Installation steps are as follows: 1. Lubricate the valve stem with a light coating of clean engine oil. From the bottom of the cylinder head, push the valve, as marked on removal, into the valve bore. NOTE: Insert a spacer beneath the valve head to prevent the valve from opening while installing the valve spring and piston. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-47