1.6 ENGINE BRAKE 2. Insert a suitable spacer about 6.0 mm (1/4 in.) in height. See Figure 1-40. 3. Install a new seal on the valve stem. [a] With the fingers, press the seal onto the valve stem past the indentation that houses the valve keepers when the valve is installed. [b] Insert the spring guide over the end of the valve stem and push down until the spring guide bottoms out. 4. From the top of the cylinder head, fit the spring and spring retainer, as marked on removal, onto the valve stem. 5. Push the spring down with the CTV spring remover and insert the valve keepers into the spring retainer. Push until they lock into place. 6. Install the piston and new seal, as removed.
Be careful not to damage the seal on installation. See Figure 1-41. 7. From the bottom of the cylinder head, remove the spacer. 8. From the top of the cylinder head, install a new O-ring on the end cover. 9. Install the end cover. 10. Install the fuel injector nozzle. Refer to section 2.6.2. 11. Install the cylinder head. Refer to section 1.3.1. 12. Repeat this procedure for each constant-throttle valve. 1.6.3 Removal of Constant Throttle Valve Solenoid Removal steps are as follows: NOTE: A Kent-Moore tool, CTV solenoid socket (J–47398) is required for this procedure. 1. Remove the lower exhaust manifold heat shield. All information subject to change without notice.
1-48 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION