Operating & maintenance manual 4 . Use the button for vibration control ( 9 ) to choose between the automatic or the manual actuation of the vibration: 13.2 Fields of application of the compaction roller The compaction rollers offer the following work modes: Simple operation (driving without vibration) Surface soil compaction Deep soil compaction 13.2.1 Basic information on soil compaction During a soil compaction process, the vehicle should run at a speed of about 1.2 to 3.0 km/h (0.75 to 1.9 mph) , i.e. 20-50 m/min (22 to 55 yards/min), depending on the composition of the soil and the dumping height. The first rolling cycle should be performed statically (i.e.
without vibration, see chapter Working with the compaction roller) and on loose material. Variations in the composition of different kinds of soil render it impossible to state generally valid figures regarding the number of compaction passes required to achieve the desired result. Therefore, trial runs are recommended means of determining the necessary amount of passes and the layer thickness. As for too many passes, not only are they uneconomical but can, on finely graded material, be the cause of extreme vibration of the roller frame which subjects the vehicle to overstraining. Under normal conditions, the required degree of compaction is generally established after 4 to 8 passes.
If the roller frame vibrates strongly, which might particularly be the case during the last passes, which call for a high degree of compaction, increase the speed to the upper limit of the recommended speed range. While carrying out static compaction passes, the maximum speed may be set as required. In order to compact soils containing rock, the size of the biggest particle may never exceed two thirds of the dumping height because only insufficient compaction will be achieved under such conditions.
65 Vibration control Manual Vibration is manually activated, as soon as you actuate switch 7 (rear of the switch pressed down) Automatic At a low driving speed, the vibration, as pre-set via switch 2, is turned on, after you actuated switch 7 (front of the switch pressed down) NOTICE Selecting the type of vibration does not activate the vibration itself.