hyundai — AW1110-AW1140 EN 05 20 1.0

Operating & maintenance manual 13.2.2 Simple operation: Forward motion (without vibration) 1. Actuate the switch ( 4 ) to deactivate the parking brake. The corresponding symbol on the dashboard is deactivated. 2. Check whether the switch for selecting the type of vibration ( 3 ) is set to the middle position ( 0 ) - OFF . 3. Set an engine speed by means of the buttons on the joystick ( 1 ). 4. Choose the desired speed: 1 2 4 3 5. Move the joystick ( 1 ) forward. The symbol for forward motion lights up on the dashboard. 6. The compaction roller starts to move forward. Fig. 71 Forward motion NOTICE The farther you move the joystick forwards, the higher the speed of the compaction roller.

As soon as the joystick reaches the end position, maximum speed is set. In the middle (neutral) position, the compaction roller stops. 13.2.3 Simple operation: Reverse motion (without vibration) Proceed as described above ( Simple operation: Forward motion (without vibration) , but move the joystick backward instead of forward. 4 The symbol indicating reverse motion ( 4 ) lights up on the dashboard. The compaction roller starts to move backwards. Fig. 72 Reverse motion 66 Measures to be taken prior to driving!

The compaction roller needs to be ready for operation with the Diesel engine started and running at operating temperature (see chapter Starting, driving and stopping the compaction roller). NOTICE Operating modes Ɣ Turtle: Front of the switch pressed down, low speed Ɣ Rabbit: Rear of the switch pressed down, high speed Risk of accidents! • Prior to any reverse movement of the compaction roller, make sure that your view to the rear is unobstructed! • Before and while driving backwards, always check the area behind you by looking backwards. WARNING