Operating & maintenance manual 14.3 Display of the compaction measurement system without data storage An easy-to-install measurement system which serves to inform the driver of the degree of soil compaction. The compaction of the soil is continuously measured by an acceleration measurement device. If the degree of compaction increases, the acceleration of the drum is increased, which, in turn, causes the values on the instrument to increase as well. As soon as the maximum compaction capacity of your vehicle has been reached, the maximum degree of compaction is set as a fixed value. The process of compacting the soil can then be terminated.
In case no solid value can be established, an analysis of the roadbed is required. The following parameters are displayed: The relative degree of compaction The more the soil is compacted, the higher the respective value. The frequency Displays the current frequency of the vibration drive as a numerical value in Hertz [Hz]. • Jump Operation on soil which has been compacted too much can cause the vehicle to jump. Fig. 80 Compaction measurement 14.4 Optional recording and documentation of the compaction work The compaction values for the current pass are saved, up to a track distance of 800 meters (875 yards).
You can directly print the saved compaction data from the optional handy thermo printer. Simply connect the printer to the display via a cable. This enables you to print the compaction course after the completion of a pass. Fig, 81 Display and printer Furthermore, there is an output option that prints the compaction data as a detailled list, which can be checked at a glance. 73 NOTICE Risk of property damage caused by jumps If the vehicle starts to jump, immediately stop the operation of the compaction roller.