4. Engine Body l Undersized bearing (0.25 mm) Code No. Standard thickness (mm) Upper Lower 4TNE106 (T) 123900-02320 123900-02330 2.613-2.628 4TNE94.98 12990d-02320 129900-02330 2.120-2.135 l Journal bearing machining dimension Journal bearing machining dimension (mm) 4TNElO6 (T) @75.702-75.712 4TNE94.98 $64.702-64.712 [NOTICE] If the oil clearance is excessive though the thicknesses of the journal and crankpin metals are normal or if partial uneven wear is observed, regrind the crankshaft and use an oversized metals. If rust or surface roughening exists on the rear side of the metals, coat it with blue or minimum.
Then assemble the crankpin metal to the connecting rod, and tighten the rod bolt to the specified torque to check the metal for contact. If the contact surface occupies 75% or more, the metal is normal. If the contact surface is insuf- ficient, the metal interference is insufficient. Replace the metal with a new one. (1) t-2) (5.3) Thrust metal inspection Inspect any damage or wear. @ Thickness l Thrust metal thickness ai If the side gap is exceeded, use an oversized thrust metal. l Oversized metal (0.25 mm) Code No. Standard thickness (mm) 4TNE94.98 129900-02370 129900-02360 Upper Lower 2.055-2.105 4TNE106 (T) 123900-02370 123900-02360 2.555-2.605 4-24