MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE Required Maintenance Operations Gaining Access To The Valves — Gain access to the valves as follows: The following sections describe the required maintenance operations listed in Table 17 and listed in Table 18. NOTE: Clean the cylinder head covers before removing it. Engine Inspecting 1. Remove the cylinder head covers. See Figure 20. Inspect engine as follows: 1. Visually check the engine for signs of leakage. A slight dampness at the sealing points is no cause for concern. NOTE: More severe leaks, combined with a continual loss of oil, must be corrected without delay. 2. Visually inspect all lines and hoses. Listen for any sound of leaking.

Make sure all pipes and hoses are undamaged, correctly positioned to avoid chafing, and properly secured. Valve Lash Checking and Adjusting A special engine cranking tool (J 46167) is required for this procedure. NOTE: Adjust the valve lash when the engine is cold. Wait at least 30 minutes after shutdown, even if the engine ran only a short time. Figure 20 Cylinder Head Cover 2. Remove the inspection cover on the flywheel housing. All information subject to change without notice. (Rev. 04/08) 69 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION