MAINTENANCE 3. Fit the cranking tool into the inspection hole on the timing case. See Figure 21. See Figure 22 for the cylinder and valve layout on the MBE 4000 engine. Figure 21 Placing Cranking Tool Choosing A Method Select a method for adjusting the valve lash. There are two acceptable methods for adjusting valve lash: Figure 22 Cylinder and Valve Layout In order, according to the timing sequence used for fuel injection (see "Method One—Adjust Each Cylinder In Firing Order") By type of valve, depending on crankshaft position (see "Method Two—Adjust All Valves Using Two Crankshaft Positions"). 70 All information subject to change without notice. (Rev.
04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION