EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE Method One — Method one allows you to adjust each cylinder in the order in which fuel is injected. The crankshaft must be repositioned after each cylinder is adjusted as listed in Table 19. NOTE: When the piston in cylinder #1 is at ignition TDC, the valves of cylinder #6 will overlap, meaning that both intake and exhaust valves are partially open, and show no measurable play when tested with a feeler gauge. 1. For each cylinder, use the cranking tool to turn over the crankshaft until the piston is exactly at top dead center (TDC) in the compression stroke. The valves must be closed and it must be possible to turn the push rods without effort. 2.
Check each valve and adjust it (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." Table 19 Valve Adjustment Method One All information subject to change without notice. (Rev. 04/08) 71 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION Engine Crankshaft Position Cylinders MBE 4000 Ignition TDC 1 5 3 6 2 4 Valve Overlap 6 2 4 1 5 3