MAINTENANCE Method Two — Method two allows you to adjust all the valves using just two crankshaft positions. 3. Using the cranking tool, turn the crankshaft until cylinder #6 is at the ignition TDC position (all valves are closed) and cylinder #1 is at the valve overlap position (all valves are open). 1. Using the cranking tool, turn the crankshaft until cylinder #1 is at the ignition TDC position (all valves are closed) and cylinder #6 is at the valve overlap position (all valves are open). 4.
Using the same procedure, check the valves listed in Table 20 in the "Valve Overlap" row and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." 2. Check the valves listed in Table 20 in the "Ignition TDC" row of and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." *I = Intake Valve, E = Exhaust Valve Table 20 Valve Adjustment Method Two 72 All information subject to change without notice. (Rev.
04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION Engine Cylinder #1 Crankshaft Position Cylinder Valve Types* 1 2 3 4 5 6 MBE 4000 Ignition TDC I/E I E I E — Valve Overlap — E I E I I/E