MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE Adjusting Valve Lash Adjust valve lash as follows: NOTE: When adjusting the valves, adjust to the exact setting. Use the range only for checking adjustment. 1. If adjustment is needed, loosen the locknut. See Figure 23. 3. Tighten the locknut 50 N·m (37 lb·ft). 4. Check the valve lash again. Adjust again if necessary. Restoring The Vehicle To Operating Condition Restore the vehicle to operation condition as follows: 1. Install the cylinder head covers. 2. Remove the cranking tool from the inspection hole in the flywheel housing. Figure 23 Valve Lash Adjustment 2. Turn the adjusting screw until the valve lash is correct.

Use the exact settings listed in Table 21. 3. Replace the end cover on the inspection hole and tighten the bolts 25 N·m (18 lb·ft). Table 21 Valve Lash Adjustment All information subject to change without notice. (Rev. 04/08) 73 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION Valve Type Check For : (mm (in.) Adjust To: (mm (in.) Intake 0.30 to 0.60 (0.012 to 0.024) 0.40 ( 0.016) Exhaust 0.50 to 0.80 (0.020 to 0.032) 0.60 (0.024)