MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

MAINTENANCE Fuel/Water Separator Prefilter Element Cleaning tighten firmly, using hands only. Clean the prefilter element as follows: 1. Loosen the bleed screw. See Figure 24. 2. Unscrew the drain plug and drain the fuel in the prefilter. 3. Twist off the sight bowl and remove the filter element from the separator head. 4. Separate the sight bowl from the filter element. Clean the sight bowl. Discard the old filter element and both O-rings. 5. Replace the filter element and O-rings. 6. Assemble the sight bowl and the prefilter element. [a] Lubricate one O-ring with a light coating of engine oil and insert it into the sight bowl. [b] Screw the prefilter element and sight bowl together. 7.

Assemble the prefilter element and the separator head. [a] Lubricate the other O-ring with a light coating of engine oil and insert it into the open end of the prefilter element. [b] Screw the prefilter element onto the separator head and Figure 24 Fuel/Water Separator 74 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION