EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE NOTE: Do not use tools to tighten the prefilter element. 8. Tighten the drain plug. 9. Prime the fuel system. [a] If equipped with a hand pump on the fuel/water separator, work the hand pump 50 times. NOTE: There should be a strong resistance in the hand pump, caused by the pressure build-up within the fuel system. [b] Crank the engine for 30 seconds at a time, but no longer. Before cranking the engine again, wait at least two minutes. The engine should start within four 30 second attempts. Fuel Pro ® 382 Fuel/Water Separator Element Replacement Replace the fuel/water separator element as follows:
Figure 25 Fuel Pro ® 382 Fuel/Water Separator All information subject to change without notice. (Rev. 04/08) 75 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION